Table of Contents
Advertisement
Managing the User Access List
The S80 supports three users. See
Each CLI command includes a description of which security levels are allowed to use that particular
command.
Table 4-1 • User Names, Levels and Access
User Name
user
config
admin
Caution:If the admin password is changed from the "Microsemi" factory default, and subsequently
forgotten, contact Microsemi support for password recovery.
Logging In
Use the following procedure to log in to the system with the Admin name/level.
1. Ensure that the S80 is connected to a LAN.
2. SSH from your computer to the assigned IP address.
3. Type your user name and press Enter. The system prompts for a password.
4. Type your password and press Enter. The system prompt appears.
Note:
The default user name is "admin" and the default password is "Microsemi". To avoid unauthorized
access, you should change from the default password.
Changing a User's Password
Use the following procedure to change a user's password.
For a description of user access levels, see
1. Login with the Admin name/level (see Logging In, on page 215).
2. For admin, type password admin and press Enter.
For config, type password config and press Enter.
For user, type password user and press Enter.
3. Follow the prompts. Change the password when prompted.
Note:
User passwords can consist of alphanumeric characters, "~", "*", "(", ")", "!", "?", "-", "_", and "." with
a minimum of 6 characters and a maximum of 8 characters.
Setting GNSS Parameters
For GNSS reference, you can specify the cable delay and the elevation mask. the angle below which the
satellites are not used by the system. You can set the track mode for GPS only (disable) or GPS +
GLONASS (enable).
Note:
It is important the cable delay be configured with the proper value. This can be determined from the
cable length.
Table 4-1
for these user names, security levels and descriptions.
Security Level
User
Users can edit the "user" password, use the "show"
commands to display information, or access any command at
the User security level.
Config
Users can edit the "config" password. Users are allowed to
change configuration and issue User-level commands.
Admin
Users are allowed to download firmware and issue
commands at any level. The admin user can modify own
password as well as the config and user password.
Table
09 8- 007 77 -0 00 Re v. A
SyncServer S80 NTP User Guide
Description
4-1.
53
Advertisement
Table of Contents
