Table of Contents
Advertisement
show status
Use this command to display the following system status information:
•
Assigned System Name
•
System Date And Time
•
System Uptime
•
Time Traceable
•
Clock Frequency Status
•
Clock Timing Status
•
Frequency State Duration in Minutes
•
Time State Duration in Minutes
•
Currently Selected Timing reference Input
•
Currently Selected Frequency reference Input
•
Frequency Offset
•
Phase Offset Value (Valid in fast-lock and normal states)
•
System Frequency PQL
Command Syntax:
show status
Level:
User, Config and Admin
Example:
S80> show status
Response:
System name : S80
System Date and time : 2017-04-18,11:35:01
Time Traceable : NO
System uptime (sec) : 13342
Clock Frequency Status : FREERUN
Frequency State Duration (min) : 216
Clock Time Status : FREERUN
Time State Duration (min) : 216
Currently Selected Frequency reference : NONE
Currently Selected Timing reference : NONE
Frequency Offset (MDEV ppb) : UNKNOWN
Phase Offset (TDEV ns) : UNKNOWN
Active Alarms : 3
System Frequency PQL : 11
Last Config time : 2017-04-17,12:45:46
upgrade
Use this command to upgrade S80 firmware with the specified filename. The user must provide the path
where the firmware file is stored. The upgrade will take approximately 7 minutes to complete.
Command Syntax:
S80> upgrade image <Path of firmware file>:<Server IP>:<User Name>
/XXX/file.tar.gz:192.168.1.2:S80
Example:
To upgrade the S80 with a firmware file /XXX/file.tar.gz at Server IP 192.168.1.2, User Name = "S80 -
S80> upgrade image /XXX/file.tar.gz:192.168.1.2:s80
WARNING:Do not remove the POE cable during the firmware upgrade. Doing so can lead to FPGA
corruption.
09 8- 007 77 -0 00 Re v. A
SyncServer S80 NTP User Guide
49
Advertisement
Table of Contents
