Mounting Site Location; Surge Protection For Outdoor Poe - Microsemi SyncServer S80 User Manual

Installation of SyncServer S80
Table 2-2 • SyncServer S80 Antenna Cable Bracket Kit - P/N 093-00001-01 (continued)
SCR SHEET-METAL #12 PHILLIPS PAN-HEAD
3/4"-LNG SS
NUT MACH HEX #M6 SS NYLON INSERT
WASHER FLAT #M6 SS

Mounting Site Location

Mount the antenna outside, preferably on the roof with an unobstructed view of the sky. Do not mount the
antenna near a wall or other obstruction blocking part of the sky. Mount the antenna well above roads or
parking lots. Proper cable, grounding techniques, and lightning arrestors should be used.
Warning:To avoid serious personal injury or death, exercise caution when working near high voltage lines.
In particular:
– Use extreme caution when installing the antenna near, under, or around high voltage lines.
– Follow local building electrical codes for grounding the chassis.Surge Protection for Indoor
PoE.
An indoor PoE should be isolated. It needs to a be single port injector, such as Microsemi's PD-9001G-
40/SP Midspan. The Primary surge protection device needs to be as close as possible to inlet to the
building and connected to earth ground. The Microsemi PD-OUT/SP11 is recommended. The single port
PoE injector acts as secondary surge protection. See
Figure 2-2 • Surge Protection with Indoor PoE

Surge Protection for Outdoor PoE

Using an outdoor PoE only makes sense for more than 1 outdoor device, for instance 1 SyncServer S80
and 1 outdoor security camera. Suggested Microsemi PoEs include the 2 port PDS-102GO or 4 port
12
Description
09 8- 007 77 -0 00 Re v. A
Quantity Part Number
2 125-12054-12-2
4 126-24704-00-2
4 126-14704-00-2
Figure 2-2.