Table of Contents
Advertisement
CLI Commands
show bridge-time:
Use this command to display the bridging time that is used to allow the frequency servo to coast through
short periods when the system does not have qualified GPS/GLONASS reference. The bridging time is in
seconds.
Command Syntax:
show bridge-time
Level:
User, Config and Admin
Example:
S80> show bridge-time
Response:
Bridging Time
Note:
If the system has not qualified a time or frequency reference within the specified bridging time the
system transitions into holdover mode of operation.
set bridge-time:
Provisions the amount of time, in seconds, the system remains in bridging mode before transitioning into
the holdover mode of operation. The bridge-time applies to both clock-timing loop and clock-frequency.
The range is 120 - 86400 seconds.
Command Syntax:
set bridge-time <time-value>
Level:
Config and Admin
Example:
S80> set bridge-time 300
32
: 300
09 8- 007 77 -0 00 Re v. A
Advertisement
Table of Contents
