Recovering Lost Ip Address With Lldp Utility - Microsemi SyncServer S80 User Manual

Troubleshooting
Table 5-1 • S80 System Messages (continued)
Description
PLL synthesizer
unlock
Temperature out of
range
Time Line has been
Changed
Phase Has Been
Aligned
System reboot
Ethernet Speed
GNSS Acquisition
status Changed
NTP Stratum
Change
NTP Leap Change
NTP Passive Mode
NTP Active Mode
NTP Service Load
Limit

Recovering Lost IP Address with LLDP Utility

The LLDP feature, which is enabled by default, provides a way for the user to discover the management
port IP address of the unit since there is no serial port connection available. When the LLDP state is
enabled, LLDP frames are sent out by the S80 every minute. The LLDP frames sent by S80 consist of
information about Management port IP address, MAC address, System name, System description, and
Ethernet port number. Any computer connected in LAN or back-to-back can know these details of the
S80 by capturing these LLDP frames using network packet analyzer software, such as Wireshark.
64
Event Default
ID Severity Transient
137 Critical No
139 Minor No
152 Event Yes
153 Event Yes
155 Event No
156 Event No
157 Event No
179 Event No
180 Event No
181 Event
182 Event
183 Event
09 8- 007 77 -0 00 Re v. A
Message Text
PLL synthesizer unlock •
•
PLL unlock cleared
No action required
Temperature out of Check your operating
range environment.
Temperature out of No action required
range cleared
Time Line has been n/a
Changed
n/a
n/a
Phase Has Been n/a
Aligned
n/a
n/a
System reboot n/a
Ethernet Speed
GNSS Acquisition
status Changed
NTP Stratum Change
NTP Leap Change
NTP Passive Mode
NTP Active Mode
NTP Service Load
Limit
Corrective Action
If alarm persists
power cycle/reboot
Call SGS support if
it persists after
reboot/power cycle.