Table of Contents
Advertisement
Installation Tools and Equipment
You will need the following tools and equipment to install the SyncServer S80:
•
Standard tool kit
•
Cat 7 waterproof cables (lengths depends on layout)
Unpacking the Unit
The SyncServer S80 (p/n 090-15200-080) is packaged to protect them from normal shock, vibration and
handling damage. (Each unit is packaged separately.)
Unpack and inspect the unit as follows:
1. Wear a properly grounded protective wrist strap or other ESD device.
2. Inspect the container for signs of damage. If the container appears to be damaged, notify both the
carrier and your Microsemi distributor. Retain the shipping container and packing material for the
carrier to inspect.
3. Open the container, being careful to cut only the packaging tape.
4. Locate and set aside the printed information and paperwork that is included in the container.
5. Remove the unit from the container and place it on an anti-static surface.
6. Locate and set aside small parts which may be packed in the container.
7. Remove the accessories from the container.
8. Remove the anti-static packaging from the unit and accessories.
9. Verify that the model and item number shown on the shipping list agrees with the model and item
number on the equipment. The item number can be found on a label affixed to the bottom of the
unit. See See
Microsemi distributor if the model or item number do not match.
The SyncServer S80 includes the Ethernet system (including sealant strip) shown in
is used to attach to the customer's cable and provide a weatherproof seal. For a complete listing of items
in the installation kit, see
Table
2-2.
Table 2-1 • SyncServer S80 Installation Kit - P/N 093-00741-000
INSTALLATION SUPPORT, OUTDOOR
ANTENNA
LOCK NUT, CONDUIT FITTING, 1-1/4 NPT SIZE
THREAD, 2.281" O.D., 0.17" THICK, STEEL,
ROHS COMPLIANT
SCREW, MACHINE, 1/4-20, 0.500" LONG, PAN
HEAD, PHILLIPS, STEEL, ZINC PLATE
WASHER FLAT, 1/4" SCREW SIZE, 0.281"ID,
0.625"OD, 0.043"-0.057" THICK, 316 SS, ROHS
Table 2-2 • SyncServer S80 Antenna Cable Bracket Kit - P/N 093-00001-01
BRACKET ANTENA MOUNT RA DUAL
FORM V-BOLT M6 SS
SCR MACH #10-32 PHILLIPS PH .125L SS
Figure 2-6
for the location of the label on the SyncServer S80. Contact your
Table
2-1. For a complete listing of items in the antenna cable bracket kit, see
Description
Description
09 8- 007 77 -0 00 Re v. A
SyncServer S80 NTP User Guide
Quantity
Part Number
1
070-02006-000
2
125-00434-000
1
125-00016-000
1
2821367
Quantity
Part Number
1
070-00377-01-2
2
070-00389-01-2
4
125-10034-02-1
Figure
2-10, which
11
Advertisement
Table of Contents
