set gnss posmode {auto | dynamic}
•
To set the GNSS dynamic position mode:
set gnss posmode dynamic {0 | 1 | 2}
where
0 = Automotive
1 = Sea
2 = Air (Not Valid Choice for S80)
•
To set the GNSS track-mode state for GLONASS:
set gnss track-mode glonass {enable | disable}
Note:
Default is enable which = GPS + GLONASS
Level:
Config and Admin
Example 1:
To enable GNSS -
S80> set gnss state enable
Example 2:
To set the GNSS elevation mask to a value of 30 -
S80> set gnss elev 30
Example 3:
To set the GNSS cable delay to a value of 200 ns
S80> set gnss cable-delay 200
Example 4
To set the position mode to auto -
S80> set gnss posmode auto
Example 5
To set the track mode to GPS only -
S80> set gnss track-mode glonass disable
show hostname
This command displays the current host name for the unit.
Command Syntax:
show hostname
Level
User, Config, and Admin
Example:
S80> show hostname
Response :
Host name
: S80
set hostname
This command sets the hostname for the unit. Hostname can contain up to 20 characters. Cli prompt, log
messages, system name in LLDP frame will get changed based on hostname.
Microsemi recommends setting a hostname. In the event that IP address is lost. you will be able to
identify the correct unit when retrieving the IP with LLDP utility. See
Command Syntax:
set hostname <hostname-string>
09 8- 007 77 -0 00 Re v. A
SyncServer S80 NTP User Guide
"Provisioning for
LLDP".
37