Basic Setup Steps: A Guide To This Section And Other Resources - Extron electronics IPL Pro Series User Manual

Basic Setup Steps: a Guide to this Section and Other Resources

NOTE: GC projects can be created offline and uploaded to the hardware at a later date.
Follow the steps in
page 7. The overall process for setting up a control processor using GC is as follows:
Figure 15.
Setup Checklist: How to Proceed With Installation
Within Global Configurator
(GC Professional or
GC Plus mode):
Create a new GC Professional or GC Plus project
No
Overall Configuration Steps
IPL Pro Series • Software-based Configuration and Control
Configure the IP settings of
the control processor and the
TouchLink Pro touchpanels.
If desired or required, install a new
security certi cate (via Toolbelt).
and add the control processor to it.
Will
TouchLink Pro or
third party touchpanels or
other user interfaces
be used?
Create GUI layouts for the
touchpanels or other interfaces:
1. Start GUI Designer.
2. Create GUI layout designs for each
TouchLink Pro, third party
touchpanel (with a TouchLink
Interface), or a computer or
mobile device (with LinkLicense).
3. Save and build the GUI layout le.
Or...
Download existing GUI layouts
from identical touchpanels.
Con gure ports on the
control processor.
Create monitors, schedules, timers,
macros, and local variables.
Add touchpanels or other interfaces
(if used) to the project.
Import GUI layouts and con gure the
touchpanels or other interfaces.
Save the project.
Build and upload the con guration to
the control processor.
Test the system, make adjustments,
nalize con guration.
starting on
See See Network Network
Communication Setup Communication Setup
on page 10.
Yes
25