Basic Setup Steps: A Guide To This Section And Other Resources - Extron electronics IPL Pro S1 User Manual

Basic Setup Steps: a Guide to this Section and Other Resources

NOTE: GC projects can be created offline and uploaded to the hardware at a later date.
Follow the steps in
page 6. The overall process for setting up a control processor is as follows:
Figure 13.
Setup Checklist: How to Proceed With Installation
Within Global Configurator
(GC Professional or
GC Plus mode):
Create a new GC Professional or GC Plus project
No
Overall Configuration Steps
IPL Pro Series • Software-based Configuration and Control
Configure the IP settings of
the control processor and the
TouchLink Pro touchpanels.
and add the control processor to it.
Will
TouchLink Pro or
third party touchpanels or
other user interfaces
be used?
Create GUI layouts for the
touchpanels or other interfaces:
1. Start GUI Designer.
2. Create GUI layout designs for each
TouchLink Pro or third party
touchpanel (with a TouchLink
Interface), or for a computer or
mobile device (with LinkLicense).
3. Save and build the GUI layout le.
Con gure ports on the
control processor.
Create monitors, schedules,
macros, and local variables.
Import GUI layouts, add touchpanels
or other interfaces (if used), and
con gure them.
Save the project.
Build and upload the con guration to
the control processor.
Test the system, make adjustments,
nalize con guration.
starting on
See "Network "Network
Communication Communication
Setup" Setup" in this
guide.
Yes
19