Settings Of The Secondary Sensor (Tss Measurement) - wtw NiCaVis 705 IQ TS Operating Manual

Commissioning
Menu item
Main sensor
Save and quit
Quit
* The UVT-254 value is standardized to 10 mm gap width.
Carrying out
settings
Menu item
Measuring mode
Measuring range
Cal - # raw value 1
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Main sensor
22
Settings
-
-

3.4.5 Settings of the secondary sensor (TSS measurement)

Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
manual.
Default values are marked in bold.
Settings
TSS
-
Value pairs of the user calibration for TSS measurement (see section
4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Explanations
Information that there are further sen-
sor overlapping settings in the setting
menu of the relevant main sensor
,
Meas. interval Cleaning duration Air
(
Signal smoothing
The system confirms the saving of the
settings and the display switches to the
next higher level.
The display switches to the next higher
level without storing the new settings.
N system operating
ENSOR ET
Explanations
Display of the measuring mode
(TSS = total suspended solids measure-
ment)
Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
Information that there are further sensor
overlapping settings in the setting menu of
the relevant main sensor (
Cleaning duration Air
etc.).
NiCaVis 705 IQ TS
,
etc.).
).
,
Meas. interval
,
Signal smoothing
ba77189e01 05/2017