Settings For Virtual Sensors - wtw NiCaVis 705 IQ TS Operating Manual

NiCaVis 705 IQ TS
Menu item
Quit
Carrying out
settings
Menu item
Measuring mode
(NitraVis 705 IQ)
Measuring mode
(CarboVis 705 IQ)
Measuring location
Measuring range
Cal - # raw value 1
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
ba77189e01 05/2017
Settings
-

3.4.4 Settings for virtual sensors

Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
manual.
Default values are marked in bold.
Settings
NO3-N

NO3

COD spectr., total

COD spectr., dissolv

TOC spectr., correl.

BOD spectr., correl.

DOC spectr., correl.

SAC 254, total

SAC 254, dissolved

UVT 254, total

UVT 254, dissolved

Outlet
(permanently set)
-
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Explanations
The display switches to the next higher
level without storing the new settings.
ENSOR
Explanations
The measured parameter is displayed
in the selected citation form.
The measured parameter is displayed
in the selected citation form.
*
*
Measurement location or application of
the sensor.
The setting is done in the setting menu
of the relevant main sensor.
Display of the measuring range
(see chapter 8 T
Commissioning
N system operating
ET
).
ECHNICAL DATA
21