Settings For The Main Sensor - wtw NiCaVis 705 IQ TS Operating Manual

Commissioning
Measuring cycle
Carrying out
settings
Menu item
Measuring mode
18

3.4.3 Settings for the main sensor

A measuring cycle consists of the cleaning procedure, the adjustment time for
the measuring system and the determination of the measured value. The follow-
ing graphic demonstrates the relevant settings:
Measuring
cycle
Measuring interval
Fig. 3-6 Measuring cycle of the sensor
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
manual.
A change of the following settings will take some time (up to a few
minutes) until it can be seen in the measured value display:
Measuring mode

Measuring location

Number of N-sensors

Number of C-sensors

Further changes can only be made when the last changes are visi-
ble in the measured value display.
Default values are marked in bold.
Settings
NO3-N

NO3

N system operating
ENSOR ET
Explanations
The measured parameter is displayed
in the selected citation form.
When changing the
setting, always check the
location
setting.
NiCaVis 705 IQ TS
Time
Measuring mode
Measuring
ba77189e01 05/2017