Main Switch; Front Brake Lever; Rear Brake Lever; Start Button - KTM Freeride E-SX Owner's Manual

Hide thumbs Also See for Freeride E-SX:
Table of Contents

Advertisement

3
CONTROLS

3.1 Main switch

3.2 Front brake lever

3.3 Rear brake lever

3.4 Start button

The main switch
is located on the right side of the handlebar.
1
Possible states
The main switch is switched off. In this position, the vehicle is
switched off.
The main switch is switched on. In this position, the vehicle is in
standby.
The main switch is used as the emergency OFF switch.
The front brake lever
is located on the right side of the handlebar.
1
The rear brake lever
is located on the left side of the handlebar.
1
The start button
is located on the right side of the handlebar. The start
1
button is only enabled when the main switch is switched on.
When the start button is pushed down for 1 second, the vehicle switches
from standby to ready mode.
The drive mode indicator and an acoustic signal indicate operating readi-
ness.
When the start button is pushed down again for 1 second, the vehicle
switches back to standby mode.
The drive mode indicator goes out, see Section 3.5.4.
Info
Standby mode can only be switched to ready mode if the throttle grip is
fully closed and the vehicle speed is less than 5 km/h.
If the vehicle is not moved for 90 seconds after ready mode is activated
and the throttle grip is not turned, the vehicle automatically switches
back to standby mode.
5

Advertisement

Table of Contents
loading

Table of Contents