KTM Freeride E-SX Owner's Manual page 22

8 TROUBLESHOOTING
8.2 Troubleshooting of the charger
The following example shows blink code 31:
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
- Read out the fault.
- Switch off the charger.
- Wait 15 seconds.
- Remedy the fault as instructed in the table.
- Switch on the charger.
Important
For all faults that are not listed in the table, switch the charger off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
Fault
Fault in the charging
cable
Fault in the charging
cable
Fault in the charging
cable
Overtemperature of the
charger
Fault in the supply
voltage
Fault in the supply
voltage
Blink Measure 1
code
11 Check the charging plug and
charging cable for external dam-
age and reconnect
12 Check the charging plug and
charging cable for external dam-
age and reconnect
13 Check the charging plug and
charging cable for external dam-
age and reconnect
51 Let the charger cool down
63 Use the "Normal" charge mode
65 Use the "Normal" charge mode
If LED flashes, there is a charger fault.
1
All of the following blink codes are displayed on the charger
and refer to the charger itself.
Measure 2
Contact an autho-
rized KTM workshop
Contact an autho-
rized KTM workshop
Contact an autho-
rized KTM workshop
Resume charging in
a cooler location
Choose a socket
closer to the central
supply
Choose a socket
closer to the central
supply
21
Measure 3
Contact an authorized
KTM workshop
Contact an authorized
KTM workshop
Contact an authorized
KTM workshop