KTM Freeride E-SX Owner's Manual page 23

8 TROUBLESHOOTING
8.3 Troubleshooting of the KTM PowerPack when connected to the charger
The following example shows blink code 31:
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
- Read out the fault.
- Switch off the charger.
- Wait 15 seconds.
- Remedy the fault as instructed in the table.
- Switch on the charger.
Important
For all faults that are not listed in the table, switch the charger off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
Fault
Overtemperature of the
KTM PowerPack
The KTM PowerPack is
too cold
The KTM PowerPack is
too cold
Fault in the charging
cable
The charge state of the
KTM PowerPack is too
high for the "Storage"
charge mode
Charging fault
Blink Measure 1
code
33 Let the KTM PowerPack cool
down
34 Place the KTM PowerPack in a
warmer location and let it warm
up
36 Place the KTM PowerPack in a
warmer location and let it warm
up
65 Check the charging plug and
charging cable for external dam-
age and reconnect
66 Ride the vehicle until the
KTM PowerPack is depleted to
50%
11 Check the charging plug and
charging cable for external dam-
age and reconnect
If LED flashes, there is a KTM PowerPack fault.
1
All of the following blink codes are displayed on the charger
and refer to the KTM PowerPack.
Measure 2
Continue charging in
a cooler location
Continue charging in
a warmer location
Continue charging in
a warmer location
Contact an autho-
rized KTM workshop
Contact an autho-
rized KTM workshop
Contact an autho-
rized KTM workshop
22
Measure 3
Contact an authorized
KTM workshop
Contact an authorized
KTM workshop
Contact an authorized
KTM workshop