KTM Freeride E-SX Owner's Manual page 16

5 ELECTRICAL SYSTEM
5.1.4 Charging the KTM PowerPack
Note
Material damage
Mount the protection cap of the charging socket while the KTM PowerPack is not connected to the charger.
Note
Material damage
The "Fast" charge mode requires at least 13 amperes of continuous current. The "Normal" charge mode requires at least
10 amperes of continuous current.
Ensure that the line supply is specified for these continuous currents and that it features the necessary fuse protection.
Note
Material damage
Ensure that the connector is correctly positioned when mounting it.
Water and dirt damage or destroy components.
Overload damages the line supply system.
The charging socket becomes damaged from incorrect handling.
The charging procedure is identical regardless of where the
KTM PowerPack is charged – while installed in the vehicle or outside
of the vehicle. However, the 12-V battery is only charged while the
KTM PowerPack is being charged in the vehicle.
Do not activate the vehicle while the charger is connected to the
KTM PowerPack.
If the vehicle is activated while the vehicle is being charged with the
KTM PowerPack installed, the vehicle switches to the fault state.
Charging of the KTM PowerPack continues but charging of the 12-V bat-
tery stops.
If you have problems charging the KTM PowerPack, consult Section 8
Troubleshooting.
- Switch off the main switch.
- Unlock the seat and fold it up.
- Remove the protection cap of the charging socket
- Check the seal of the protection cap of the charging socket.
- Connect the charger with the KTM PowerPack. Note the connector
marking
- Connect the power plug of the charger to the line socket.
- Set the charge mode switch
- Switch on the charger using switch
Charging starts automatically. The status indicator flashes while the sys-
tem is charging, see Section 5.1.1.
.
A
to "Fast" or "Normal".
2
.
1
.
3
15