Vehicle Troubleshooting - KTM Freeride E-SX Owner's Manual

8 TROUBLESHOOTING

8.1 Vehicle troubleshooting

The blink codes are displayed by the yellow electric motor indicator lamp.
The following example shows blink code 31:
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
Important
For all faults that do not appear in the table, switch the vehicle off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
Fault
Switch-off due to low
charge state
Fault during charging
Overtemperature of the
control unit
Overtemperature of the
motor
Overtemperature of the
KTM PowerPack
Fault in the CAN com-
munication
Fault in the com-
munication with the
KTM PowerPack
Fault in the communi-
cation with the multi-
function display
Blink Measure 1
code
11 Charge the
KTM PowerPack
13 Stop charging,
switch off the main
switch, and restart
charging
22 Check the coolant
level
23 Check the coolant
level
24 Let the KTM Power-
Pack cool down
31 Switch the main
switch off and on
33 Switch the main
switch off and on
34 Switch the main
switch off and on
Measure 2
Test the new Contact an authorized
KTM PowerPack KTM workshop
Contact an
authorized KTM
workshop
Check the radiator Contact an authorized
for dirt KTM workshop
Check the radiator Contact an authorized
for dirt KTM workshop
Contact an
authorized KTM
workshop
Check the correct Check the connection
positioning of the of the multifunction
KTM PowerPack display for loose con-
Check the correct Contact an authorized
positioning of the KTM workshop
KTM PowerPack
Check the con- Contact an authorized
nection of the KTM workshop
multifunction
display for loose
connectors
Measure 3 Measure 4
Contact an au-
thorized KTM
workshop
nectors
19