KTM Freeride E-SX Owner's Manual page 17

5 ELECTRICAL SYSTEM
If LED 5 of the charge state indicator on the charger flashes, the KTM PowerPack is ready to use. However, full capacity is
not yet available.
To ensure maximum power of the KTM PowerPack, fully discharge the KTM PowerPack and recharge it again fully every
20 charge cycles. If this procedure is not followed, the vehicle may switch off due to a low charge state without first
reducing the power.
The KTM PowerPack is fully discharged when the vehicle switches off with blink code 11, see Section 8.1.
If the temperature of the KTM PowerPack exceeds the permissible value while it is being charged, the charger stops
charging. The status indicator lights up permanently.
After the temperature of the KTM PowerPack returns to the permissible range, charging is resumed automatically.
The charge state is indicated by five LEDs.
LED 1: 20 %
LED 2: 40 %
LED 3: 60 %
LED 4: 80 %
LED 5: flashes until 100% is reached.
After the charging process is completed, all five LEDs light up while the
status indicator is switched off.
- Switch off the charger using switch
- Disconnect the charging cable from the KTM PowerPack.
- Check the seal of the protection cap of the charging socket.
- Mount the protection cap of the charging socket.
- Fold down the seat and lock it.
16
.
4