Installation And Connection; Installation - NEC Express5800 Series User Manual

Chapter 2 Preparations
2.

Installation and Connection

This section describes how to position the server and connect cables.
2.1

Installation

The environment suitable for the server is as follows.
Hold the server firmly, and slowly and gently place it in the position in which it is to be installed.
The environment that satisfies the
following conditions:
<Operating>
Ambient temperature:5°C to 40°C*1
Humidity: 10% to 85% *2
Temperature gradient: ±10°C/hour
Air pressure: 749 to 1040 hpa
<Non-operation>
Ambient temperature:5°C to 40°C*1
Humidity: 10% to 85% *2
Temperature gradient: ±15°C/hour
Air pressure: 749 to 1040 hpa
*1: 5°C to 48°C (when an optional
kit is installed; subject to
composition restrictions)
*2: 10% to 80% (when internal
LTO is installed)
W ARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety Precautions and Regulatory Notices.
 Use only in the specified environment.
 Do not connect the ground wire to a gas pipe.
CAUTION
Be sure to observe the following precautions to use of the server safely. Failure
to observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety Precautions and Regulatory Notices..
 Do not attempt to lift the server by gripping the front bezel.
 Do not carry or install the server only by a single person.
 Install and store only in the specified environment.
At least 150 mm clearance in
front of/behind the server
100/200VAC bipolar grounded
outlet or bipolar outlet with
ground terminal (separate
adapter is required)
Express5800/T110i User's Guide
2. Installation and Connection
Cables for the mouse or other
devices are within easy reach
On a flat and
sturdy desk
A Dust-free, clean, and
organized room
95