Turning On The Server - NEC Express5800 Series User Manual
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
1. Disconnect Flash FDD if applicable.
2. Turn on the peripheral devices such as display unit.
3. If STATUS LED1,2 lights green/amber, wait until STATUS LED is unlit.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, NEC
logo appears on the display.
While the logo is being displayed, the self-diagnostic
program (POST) runs and diagnoses the hardware. For
details, see Chapter 3 (1.1 POST).
Important
Wait for at least 30 seconds before turning on the server again after the
power has been turned off.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/T110i User's Guide
1. Turning on the Server
POWER
LED
POWER
switch
103
Advertisement
Table of Contents
