Optical Disk Drive; Replacing Drives - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.12

Optical Disk Drive

Procedures for replacing the standard optical disk drive with the optional internal DVD SuperMULTI drive are
described below.
1.12.1

Replacing drives

Follow the procedure below to replace your drive with the optional internal DVD SuperMULTI drive.
1. See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2. To remove the side cover and front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3. Remove the duct. If a device is installed in the 5.25-inch expansion bay 1, remove it so that you can
access the cable connected to the optical disk drive.
4. Disconnect the SATA cable and DC power cable
from the optical disk drive.
5. Push the stopper on the right side and remove the
optical disk drive.
6. Remove the bracket from the optical disk drive.
7. Mount the bracket for the optical disk drive on the DVD SuperMULTI drive.
8. Install the bracket with DVD SuperMULTI drive installed to the server.
9. Connect the SATA cable and DC power cable you disconnected in step 4 to the server.
This completes the installation procedures.
1.12.2
Removal
You can remove the optical disk drive by reversing the installation procedure.
Important Do not install a drive manufactured by a third party.
Express5800/T110i User's Guide
1. Installing Internal Optional Devices
75