Cases That Require Setting Changes - NEC Express5800 Series User Manual

Chapter 3 Setup
2.4

Cases that Require Setting Changes

Specify parameters according to the following table when your system matches "Description". Other than
cases described below, do not change the settings. The list of SETUP parameters and factory settings are
described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Install a
Optional
board
board
Memory Configure the memory after the
DIMM is added or exchanged.
Boot Set to UEFI in Boot mode
depending on the installed OS.
Set to Legacy in Boot mode
depending on the installed OS.
Change the boot order of
devices
Use remote power on feature
(from RTC alarm)
Control from HW console
terminal
Set to Enabled in X2APIC
depending on the installed OS.
Set to Disabled in X2APIC
depending on the installed OS.
110
Description
Main  System Date
Main  System Time
Boot  Bootup Numlock State
Boot  Quite Boot  Disabled
RAID controller
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCI Slot n Option ROM 
Enabled
Advanced  Memory Configuration 
Memory Retest  Yes
Boot → Boot Mode → UEFI
The following OS must be set to UEFI:
－ Windows Server 2016
－ Windows Server 2012
－ Windows Server 2012 R2
－ VMware ESXi 6
－ VMware ESXi 6.5 Later
Boot  Boot Mode  Legacy
Boot  Boot Option Priorities 
Change the boot priority
Advanced  Advanced Chipset
Configuration  Wake On RTC Alarm
 Enabled
Advanced  Serial Port Configuration
 Change respective setting.
Advanced  Processor Configuration
 X2APIC  Enabled
The following OS must be set to Enabled:
－ Windows Server 2016
－ Windows Server 2012
－ Windows Server 2012 R2
－ VMware ESXi 6
－ VMware ESXi 6.5 Later
Advanced  Processor Configuration
 X2APIC  Disabled
Express5800/T110i User's Guide
To be changed
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
n is PCI slot number of the RAID
controller
After rebooting, the Memory
Retest setting changes to No
automatically.
For details, see Installation
Guide.
For details, see Installation
Guide.
For details, see Installation
Guide.to select Enabled or
Disabled.
For details, see Installation
Guide.to select Enabled or
Disabled.
2. System BIOS Setup
Remark