Link/Act Led ( 1, 2, M); Speed Led ( 1, 2, M); Ac Power Led - NEC Express5800 Series User Manual

Chapter 1 General Description
4.5.7
LINK/ACT LED (
This LED indicates the status of the LAN port.
LINK/ACT LED pattern
On (green)
Blinking (green)
Off
4.5.8 SPEED LED (
This LED indicates which network interface is used.
 Two onboard LANs (
 Management LAN (
SPEED LED pattern
On (amber)
On (green)
Off
4.5.9

AC POWER LED

If an optional redundant power supply unit is installed, an AC POWER LED is added to the unit.
LED status
On (green)
Blinking (green)
On (amber)
Blinking (amber)
Off
1, 2, M)
The server is correctly connected with network.
The server is accessing network.
The server is disconnected from network.
1, 2, M)
1, 2) support 1000BASE-T, 100BASE-TX, and 10BASE-TX.
M) supports 100BASE-TX and 10BASE-TX.
The port is operating with 1000BASE-T interface.
The port is operating with 100BASE-TX interface.
The port is operating with 10BASE-T interface.
Condition
The server is on.
AC power is being supplied via the
power cord.
Cold redundancy is enabled.
A redundant power supply system is
configured and a power cord is only
connected to one of the power supply
units.
The power supply unit detects
abnormality and stops because
safety.
The power supply unit is detecting an
omen of an abnormal.
The power is not supplied to the
server.
Express5800/T110i User's Guide
4. Names and Functions of Parts
Description
Description
Description


Connect the power cord to the other power
supply unit.
Contact your sales representative.
Connect the power cable. If the LED is
not lit although power cord is connected,
contact your sales representative.
31