Input Source Selection (Input 2 Terminal/Hdcp, Component, Scart) - Sanyo PLV-Z2 Owner's Manual

Input Source Selection (INPUT 2 Terminal/HDCP , Component, Scart)
Direct Operation
INPUT button
Choose Input 2 by pressing the INPUT button on the top control or on
the remote control. Before using these buttons, correct input source
should be selected through menu operation as described below.
Menu Operation
1 Select the Input Menu with the Point Up/Down button, and then
press the Point Right button to enter the sub-menu.
2 Select Input 2 with the Point Up/Down button and then press
the Point Right button. The Source Select Menu will appear.
3 Move the pointer to the source that you want to select and then
press the SELECT button.
RGB (AV HDCP) When the input source compatible with HDCP is
coming from video equipment through the DVI ter-
minal, select RGB (AV HDCP).
Component When the input source is coming from video
equipment connected to the DVI terminal with a
Component-DVI Cable, select Component.
RGB (Scart) When the input source is coming from video
equipment connected to the DVI terminal with a
Scart-DVI Cable, select RGB (Scart).
NOTE
G HDCP (High-bandwidth Digital Content Protection) is a system for
protecting digital entertainment content delivered by DVI (Digital Visual
Interface) from being copied.
The specification of HDCP is decided and controlled by Digital Content
Protection, LLC. Should the specification be changed, this projector may
not display the digital content protected by HDCP.
G
Component-DVI Cable and Scart-DVI Cable are options. See page 55 for
order.
INPUT button
Input 2
Input 1
Top Control Remote Control
MENU INPUT
SELECT
INPUT button
Input Menu
Source Selection Menu
pointer
Closes the source selection menu.
Video Input
25