Input Source Selection (Component, Rgb Scart 21-Pin) - Sanyo plc-wxl46a Owner's Manual

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation
Select Computer 1 by pressing the INPUT button on the top
control or COMPUTER button on the remote control.
Before using INPUT or COMPUTER button, select the
correct input source through Menu operation as described
below.
Menu Operation
1
Use the MENU button to display the On-Screen Menu.
pointer to the Input Menu icon.
2
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to Component or RGB (Scart) and
then press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable (not supplied),
select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Scart-VGA Cable (not supplied), select
RGB (Scart).
Note:
•Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.44).
•Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.44)
Top Control
INPUT button
Remote Control
COMPUTER button
COMPUTER button
*See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to Component
or RGB (Scart) and press the
SELECT button.
Video Input
INPUT button
Computer 1
*
Computer 2
Video
Computer 1
Computer 2
*
35