Video Input; Input Source Selection (Input 1 Terminal/Video, S-Video, Component) - Sanyo PLV-Z2 Owner's Manual

Video Input

Input Source Selection (INPUT 1 Terminal/Video, S-Video, Component)

Direct Operation
INPUT button
Choose Input 1 by pressing the INPUT button on the top control or on
the remote control. Before using these buttons, correct input source
should be selected through the INPUT 1 buttons on the remote
control or through menu operation as described on the next page.
INPUT 1 buttons
Press the AUTO, VIDEO, S-VIDEO, or COMPO button on the remote
control according to video input.
It is convenient for you to select the AUTO as the projector automati-
cally detects incoming video signal, and adjust itself to optimize its
performance.
AUTO When selecting the AUTO button, the projector automati-
cally detects incoming video signal, and adjusts itself to
optimize its performance. However, the projector
selects connection in the following order under the condi-
tion of connecting more than one input source:
1st Y-Pb/Cb-Pr/Cr
2nd S-VIDEO
3rd VIDEO
Y-Pb/Cb-Pr/Cr has priority over S-VIDEO. S-VIDEO has
priority over VIDEO.
VIDEO When video input signal is connected to the VIDEO jack,
select Video.
S-VIDEO When video input signal is connected to the S-VIDEO
jack, select S-Video.
COMPO When video input signal is connected to the Y-Pb/Cb-
Pr/Cr jacks, select COMPO.
INPUT button
Input 1
Input 2
Top Control Remote Control
INPUT
SELECT
INPUT button
Remote Control
INPUT 1 buttons: AUTO / VIDEO / S-VIDEO / COMPO
23