Remote Control Operating Range; Remote Control Batteries Installation - Sanyo PLV-Z2 Owner's Manual

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control is about 16.4' (5m) and 60° in front of the projector.

Remote Control Batteries Installation

Remove the battery
1
compartment lid.
Pull up the lid
and remove it.
* When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 1)(p41).
To insure safe operation, please observe the following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with a used battery.
G Avoid contact with water or liquid.
G Do not expose the remote control to moisture, or heat.
G Do not drop the remote control.
G If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
16.4'
(5 m)
60°
Slide the batteries
2
into compartment.
Two AA size batteries
For correct polarity (+ and
–), be sure battery termi-
nals are in contact with
pins in compartment.
Part Names and Functions
Replace the compartment lid.
3
13