Computer Adjustment (Manual) - Sanyo PLV-Z2 Owner's Manual

Computer Input

Computer Adjustment (Manual)

Some computers employ special signal formats which may not be tuned by Multi-scan system of this projector. This
projector has Manual PC Adjustment to enable you to precisely adjust several parameters to match those signal formats.
The projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to
recall the setting for a specific computer whenever you use it.
1 Select the PC Adjust Menu with the Point Up/Down button, and
then press the Point Right button to enter the sub-menu.
2
Select an item with the Point Up/Down button and press the
Point Left/Right button to adjust each item.
Fine sync
Adjusts an image as necessary to eliminate flicker from the display.
Press the Point Left/Right button to adjust value. (From 0 to 31)
Total dots
Adjusts the number of total dots in one horizontal period. Press the
Point Left/Right button and adjust number to match your PC image.
Horizontal
Adjusts horizontal picture position. Press the Point Left/Right button
to adjust the position.
Vertical
Adjusts vertical picture position. Press the Point Left/Right button to
adjust the position.
Current mode
Press the Point Right button to show the information of the
connected computer.
Clamp
Adjusts clamp level. When the image has dark bars, try this
adjustment.
34
PC Adjust Menu
Selected Mode
This arrow indicates that there
are other items. Select this
item and press the Point Down
button to go to the next item.
Press the SELECT button to
adjust the next item.
Press the MENU button to
return to the previous On-
Screen Menu and store the
adjusted value.
Go on to the next page...
Shows status
(Stored / Free) of the
selected Mode.