Sanyo PLV-Z2 Owner's Manual page 41

Lamp mode
This function allows you to change brightness of the screen.
···· normal brightness
···· the controlled brightness according with input signal
···· lowers brightness and reduces the lamp power consumption.
Remote control
This projector has two different remote control codes: Code 1 (initial
code) and Code 2. This switching function prevents remote control
interference when operating several projectors or video equipment
together.
When operating the projector in "Code 1", both the projector and
the remote control must be switched to "Code 1".
To change the code of the projector;
Set the remote control code in the Setting Menu to "Code 2".
To change the code of the remote control;
Press both the MENU and the IMAGE button on the remote control
together for over 10 seconds.
After changing the code, make sure the remote control operates
properly.
To return to the initial code (Code 1), repeat the steps above.
Lamp counter reset
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter by
using this function. See page 46 for operation.
Factory default
This function returns all setting values except for the lamp counter to
the factory default settings.
NOTE
G
You can also select a lamp mode with the LAMP MODE (LAMP) button on
the remote control. (p12)
G
When the batteries of the remote control are replaced, the remote control
code automatically returns to the initial code (Code 1).
Lamp mode
Factory default
Setting
Select Factory
default and this box
appears. Select
[Yes] , and the next
box appears.
Select [Yes] to acti-
vate it.
41