Sanyo PLV-Z2 Owner's Manual page 40

Setting
Capture
This function is used to capture the image being projected and use it
for a starting-up display or interval of presentations. After capturing
the projected image, go to the Logo function and set it as "User".
Then the captured image will be displayed when turning on the
projector next time or pressing the MY PICTURE (MY-P) button on the
remote control. (p12)
To capture the image, select [Yes]. To cancel the Capture function,
select [No].
Ceiling
When this function is "On," the picture is top/bottom and left/right
reversed. This function is used to project the image from a ceiling
mounting the projector.
Rear
When this function is "On," the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Power management
For reducing power consumption as well as maintaining the lamp life,
the Power management function turns off the projection lamp when
the input signal is interrupted and no button is pressed for 30 seconds
or more.
When the input signal is interrupted and no button is pressed for 30
seconds or more, the timer display with the message "No signal"
appears on the screen. The count-down starts for 5 minutes.
When the count-down time has elapsed, the lamp will be turned off to
cool itself down. The POWER indicator is flashing red during this
cooling-off period. The next performance depends on setting as
follows.
On ··· When the lamp has been fully cooled down, the POWER
indicator changes to green flashing. In this condition, the
projection lamp will be turned on if the input signal is
reconnected or any button on the top control or remote
control is pressed.
Off ··· The Power management function is canceled.
Power off confirmation
The confirmation dialog box to turn off the projector is displayed with
this function ON.
NOTE
G Before capturing an image, select Standard in the Image Select Menu to
capture a proper image. (p27, 36)
G A signal from a computer can be captured up to XGA(1024 x 768). If
selecting 1280 x 1024 at Display area in the PC Adjust Menu (p35), then the
image cannot be captured.
G A signal from video equipment can be captured except for 720p, 1035i,
1080i, and a signal compatible with HDCP.
G When capturing the image that has been adjusted by the Keystone function,
the adjustment data is automatically reset and the projector captures an
image without keystone adjustment.
G If the Capture function fails to capture an image, the On-Screen Menu
returns to the Capture item.
G If capturing a signal which is not able to be captured, an exclamation mark
appears and the function will not be available.
G If cancelling the Capture function in the middle of operation, the last
captured image will be deleted.
40
Capture
Ceiling
Rear
This arrow indicates that there
are previous items. Select this
item and press the Point Up but-
ton to go to the previous item.
Power management
Time left until
lamp off