Remote Control Battery Installation; Remote Control Operating Range - Sanyo PJLink PDG-DXL100 Owner's Manual

All manuals and user guides at all-guides.com
Introduction
Open the battery com-
1
partment lid.
Use two (2) AAA type batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
install new batteries.
Risk of an explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
control code will not be returned to default.
The original setting will be kept and will not be erased.
Point the remote control
Infrared Remote
toward the projector (In-
Receiver is provided
frared Remote Receiver)
on the top of the pro-
jector.
when pressing any button.
Point the remote
control from obliquely
for the remote control is
above toward the In-
frared Remote Receiver
top of the projector.
when operating the
remote control.
12
English

Remote Control Battery Installation

Install new batteries into the
2
compartment.
terminals are in contact
with pins in the com-
partment.

Remote Control Operating Range

Replace the com-
3
partment lid
.
39.4' (12m)
Approx.30°