Remote Control Operating Range; Remote Control Batteries Installation - Sanyo PLC-XE20 Owner's Manual

Table of Contents

Advertisement

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control is about 16.4' (5m) and 60° in front of the projector.

Remote Control Batteries Installation

Remove the battery
1
compartment lid.
Press the lid down-
ward and slide it.
To insure safe operation, please observe the following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with a used battery.
G Avoid contact with water or liquid.
G Do not expose the remote control to moisture, or heat.
G Do not drop the remote control.
G If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
16.4'
(5 m)
60°
Slide the batteries into
2
the compartment.
Two AA size batteries
For correct polarity (+ and
–),
be
terminals are in contact
with pins in compartment.
Part Names and Functions
Replace the compartment
3
lid.
sure
battery
15

Advertisement

Table of Contents
loading

Table of Contents