3. External Connection
In the case of COM-2PD(PCI)H
Connecting directly to the port connector
If connecting an external device directly from the connector on the board, use a CN5-D9F or equivalent
connector.
Pin Assignment
Screw nut: UNC#4-40(inch screw)
1
6
CN1
9
5
1
6
CN2
9
5
- Connector used
- Applicable connector
Figure 3.1. Interface Connector < COM-2PD(PCI)H >
Clear to Send- CTS1-
Clear to Send+
CTS1+
Receive Data+
RxD1+
Receive Data-
RxD1-
Clear to Send- CTS2-
Clear to Send+
CTS2+
Receive Data+
RxD2+
Receive Data-
RxD2-
Figure 3.2. Pin Assignments of Interface Connector < COM-2PD(PCI)H >
CAUTION
For TxD, RxD, and RTS, even numbered pins are + and odd numbered pins are -.
For CTS, even numbered pins are - and odd numbered pins are +. This is the opposite of the other
signals, but is not a misprint.
34
DELC-J9PAF-20L9 (mfd. by JAE, Male)equivalent
17JE-13090-02(D8C) (mfd. by DDK, Female)
CN5-D9F (mfd. by CONTEC, Female) (Five connector set)
1
SG1
Signal Ground
6
2
RTS1+
Request to Send+
7
RTS1-
Request to Send-
3
8
4
TxD1+
Transmit Data+
9
TxD1-
Transmit Data-
5
CN1
1
SG2
Signal Ground
6
2
RTS2+
Request to Send+
7
RTS2-
Request to Send-
3
8
4
TxD2+
Transmit Data+
9
TxD2-
Transmit Data-
5
CN2
COM-2PD(PCI)H, COM-4PD(PCI)H