Step 1 Setting the Hardware
This section describes how to set the board and plug it on your PC.
The board has some switches and jumper to be preset.
Check the on-board switches and jumpers before plugging the board into an expansion slot.
The board can be set up even with the factory defaults untouched. You can change board settings later.
Parts of the Board and Factory Defaults
Figure 2.1.to Figure 2.2 shows the names of major parts on the board.
Note that the switch setting shown below is the factory default.
COM-2PD(PCI)H
COM-2PD(PCI)H
CN1
SW2
SW4
CN2
- Interface connector
(CN1, CN2)
Figure 2.1. Component Locations < COM-2PD(PCI)H >
COM-2PD(PCI)H, COM-4PD(PCI)H
SW1
BOARD ID
- Terminator
setting swich
(SW2, SW4)
ON
1
2
3
4
SW2
ON
1
2
3
4
SW4
Board ID setting switch
(SW1)
SW1
BOARD ID
8
- Data transmission
mode setting swich
(SW3, SW5)
2. Setup
11