READ BEFORE BEGINNING INSTALLATION/PROGRAMMING/SET-UP
HOW TO USE THE REMOTE CONTROL
red
After unlocking, the red
LED flashes and the sensor
can be adjusted by remote
control.
ADJUSTING ONE OR MORE PARAMETERS
red
CHECKING A VALUE
red
4
green orange green
RESTORING TO FACTORY VALUES
red
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
red
DELETING AN ACCESS CODE
red
Enter the existing code
30 minutes after last use, the sensor locks access to the remote control session. To regain access,
cycle the power. The remote control session will then be accessible for another 30 minutes.
Page 4 of 12
Page 4 of 12
red
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
red
red
= field width: 4.2 m
1
2
red
red
red
red
= field width is defined by Learn
3
orange
X = NUMBER OF FLASHES = VALUE OF THE PARAMETER
x
To end an adjustment session,
always lock the sensor.
red
x
green
Learn
red
75.5792.05 LZR-S600 20180814
75.5792.05 LZR-S600 20180814
off
off
off
green
off
off
30'