How To Use The Remote Control - BEA LZR P110 User Manual

HOW TO USE THE REMOTE CONTROL

4 hours after last use, the sensor locks the access to the remote control session.
Cut and restore power supply. The remote control session is accessible again during 4 hours.
After unlocking, the red
LED flashes and the sensor
can be adjusted by remote
control.
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
Enter the existing code
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAFETY FIELD TEACH-IN
4
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
x = number of flashes = value of the parameter
4x
= field width is defined by teach-in
3x
3 s
To end an adjustment session,
always lock the sensor.
x
= field width: 4.2 m
1x 2x
teach-in
max. 30 s
4h