Advertisement
HOW TO USE THE REMOTE CONTROL
After unlocking, the red
LED flashes and the sensor
can be adjusted by remote
control.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
Enter the existing code
30 minutes after last use, the sensor locks the access to the remote control session.
Cut and restore power supply. The remote control session is accessible again during 30 minutes.
X = NUMBER OF FLASHES = VALUE OF THE PARAMETER
x
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
To end an adjustment session,
always lock the sensor.
x
= field width: 4.2 m
4
1
2
= field width is defined by teach-in
3
9
Advertisement
