Hyundai Kona Electric 2018 Owner's Manual page 475

What to do in an emergency
Checking the tire inflation
pressure
1. After driving approximately 7~10
km (4~6 miles or about 10 min),
stop at a safety location.
2. Connect the filling hose (3) direct-
ly into the compressor.
6-20
3. Connect the filling hose (3) of the
compressor directly to the tire
valve.
4. Plug the compressor power cord
into the vehicle power outlet.
OAEPH067042
5. Adjust the tire inflation pressure to
the recomended tire inflation.
With the vehicle ON (
ON), proceed as follows.
- To increase the inflation pres-
sure : Switch on the compressor.
To check the current inflation
pressure setting, briefly switch off
the compressor.
- To reduce the inflation pres-
sure: Press the button (9) on the
compressor.
NOTICE
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
i
Information
The pressure gauge may show higher
than actual reading when the com-
pressor is running. To get an accurate
OOSEV068007
tire reading, the compressor needs to
be turned off.
If the inflation pressure is not
maintained, drive the vehicle a
second time, refer to Distributing
the sealant. Then repeat steps 1
indicator
to 4.
Use of the TMK may be ineffec-
tual for tire damage larger than
approximately 4 mm (0.16 in).
We recommend that you contact
an authorized HYUNDAI dealer if
the tire cannot be made road-
worthy with the Tire Mobility Kit.
CAUTION