Table of Contents
Advertisement
CDD-562AL/564A/L Multi-Channel Demodulator
Ethernet-based Remote Product Management
7.3.8.2.3
Protocols Group
Use protocols groups to control networking protocols such as IGMP.
7.3.8.2.3.1 IGMP Subgroup
This subgroup controls the Internet Group Management Protocol (IGMP), which is the standard for IP
multicasting in the Internet.
7.3.8.2.3.2 VLAN Brouter Config Subgroup
This subgroup controls the VLAN Brouter operating mode state, and VLAN Brouter Next Hop MAC
address.
7.3.8.2.3.3 ARP Config Subgroup
This subgroup controls the ARP Table and entries.
7.3.8.2.4
Demodulator Configuration Group
IMPORTANT NOTE: Every time you change the demodulator parameters using
SNMP, you must change these parameters in this sequence:
1.
2.
3.
4.
Use this group to configure the demodulator parameters.
For detailed OID information, see the MIB file.
7.3.8.2.4.1 Rx Parameters
Use this section to configure the demodulators' parameters.
7.3.8.2.4.2 Alarm Mask Parameters
Use this section to mask the AGC, Eb/No and LNB alarms.
7.3.8.2.4.3 LNB Parameters
Use this section to configure LNB parameters when an LNB is attached to the demodulator.
FEC (Forward Error Correction)
Demodulation
Code Rate
Data Rate
7–7
Revision 0
MN-CDD562AL564AL
Advertisement
Table of Contents
