Table of Contents
Advertisement
CDD-562AL/564A/L Multi-Channel Demodulator
HTTP (Web Server) Interface
Next Hop IP
Change the the Next Hop IP to set the locally-attached router's IP address to be used for routing to the
destination network. This is applicable when there is another subnet addressed to the modem on the LAN
side.
Depending on the active Working Mode, set the address within these ranges:
•
Point-to-Point – No HDLC address
•
Small Network – 0x1 to 0xFE
•
Large Network – 0x1 to 0xFFFE
Multicast Options
Select the applicable option:
•
N/A
•
Forward
•
Filter
When finished, click Submit Changes to save and activate these changes.
A dd New R oute
Use this page section to add a new route to the Route Table.
Name
Enter a name for the Route Table Entry. The name must be unique and cannot have any whitespace.
Dest. IP/Mask
Enter an address that sets the route to the destination network.
Interf.
The Interface is fixed at "toEthernet". You cannot change it.
Next Hop IP
Use the Next Hop IP to set the locally-attached router's IP address to be used for routing to the
destination network. This is applicable when there is another subnet addressed to the modem on the LAN
side.
Depending on the active Working Mode, set the address within these ranges:
•
Point-to-Point – No HDLC address
•
Small Network – 0x1 to 0xFE
•
Large Network – 0x1 to 0xFFFE
10–26
Revision 0
MN-CDD562AL564AL
Advertisement
Table of Contents
