Table of Contents
Advertisement
CDD-562AL/564A/L Multi-Channel Demodulator
Telnet and CLI Operation
Filtered – Bad Header Len
•
Filtered due to packets received with less than 14 bytes of L2 header.
Filtered – Bad Data Ptr
•
Internal error occurred while accessing the packet data.
Filtered – MAC Split Err
•
Not currently used.
Filtered – L3Type Err
•
Not currently used.
Filtered – Local Destination
•
Packet received with destination MAC as modem MAC and destination IP is not modem IP while
modem is operating in bridge mode (EasyConnect)
Filtered – Redundancy Err
•
Applies to Offline modem in 1:1 Redundancy
•
Packets will be received on the WAN port by the both Offline unit and Online unit, only Online
unit is allowed to forward the packets. Indicates packets received by Offline unit from WAN port
that were filtered because unit is Offline.
Filtered – ICMP Filter
•
This is the same as "Filtered Ping", except this will update in easyConnect mode.
Filtered – Port Err
•
Non-IP or ARP packets are targeted to End-station. (End-station will not allow any non-IP
packets.)
Filtered – Per port route rule
•
In 1:1 Redundancy Easy connect mode – a packet received with modem destination MAC, but the
IP does not match the traffic IP or management IP.
•
In Router mode - per port WAN filtered mode is ON.
Filtered – VLAN Mismatch
•
VLAN brouter mode, if the incoming packet's VLAN ID is not matched to the VLAN table.
Filtered – VLAN Tag/Untagging Failed
•
Packets that the VLAN tag can be removed from or added to the packet (internal processing
errors).
Filtered – Dedicated Mgmt Access
•
Packets dropped because of invalid physical ingress port and packet type association. Example:
Packet from Traffic Port trying to access the Management subnet is restricted and filtered.
Filtered – Total
•
Total Filtered Packets
9–50
Revision 0
MN-CDD562AL564AL
Advertisement
Table of Contents
