CDD-562AL/56xA/L Multi-Channel Demodulator
Dedicated Management Port
C.4.3 Route Table requirements
You must use Route Tables to allow local and remote M&C access when in Router Mode. See Figure
C-6.
Note, because the CDD-564A/L is a demodulator, there is no issue of sending it over the WAN interface.
C.4.3.1
Steps to set Route Tables to allow local M&C access
1.
From the CLI Main Menu, type
2.
On the Route Table menu:
a.
Type a Route number to change an assigned Route
D
b.
Or type
to delete an assigned route
3.
Type S to save the change.
1
R
to go to the Route Table menu.
Figure C-6. CDD-564A/L Route Tables
C–6
Revision 0
MN-CDD562AL56xAL