Comtech EF Data CDD-562AL Installation And Operation Manual page 120

CDD-562AL/564A/L Multi-Channel Demodulator
Telnet and CLI Operation
9.2.2.1.5 SNMP Configuration screen
Go to the SNMP Configuration screen from the Administration screen.
Use this screen to set management parameters for Simple Network Management Protocol.
SNMP Read Community, keystroke: R
•
(GET community) Allows GET operations to all portions of the demodulator Controller and
Quad Demodulator MIBs.
SNMP Write Community, keystroke: W
•
(SET community string) Allows SET operations to all portions of the demodulator Controller and
Quad Demodulator MIBs.
SNMP Trap Community, keystroke: T
•
Defines Community String that will be set in the Community field of all outgoing traps. This field
on the trap PDU may be checked by the network manager application to determine if the trap
came from a "trusted" agent.
SNMP Trap Destination #1, keystroke: D
•
IP address where all traps/notifications will be sent. If a network management application is
running in the network, it should be configured to receive traps and its IP address should be
entered here. Supports 2 – Trap Destinations.
SNMP Trap Destination #2, keystroke: 2
•
IP address where all traps/notifications will be sent. If a network management application is
running in the network, it should be configured to receive traps and its IP address should be
entered here. Supports 2 – Trap Destinations.
SNMP Trap Version, keystroke: V
•
Sets which notification is sent, either SNMPv1 or SNMPv2.
9–14
Revision 0
MN-CDD562AL564AL