Download  Print this page

Multi-Handset Use - Sanyo LNS-W10 Instruction Manual

2.4 ghz digital cordless telephone with 2 caller id handsets and extra charger
Hide thumbs

Advertisement


Check the power connection by switching off the power at the main socket,
waiting a few seconds, then switching it back on.

Check to make sure that the phone and base unit are with in transmission
range.

The handset may be unable to find the base unit. Try moving the handset
closer to the base unit. If the problem persists, try moving the base unit in a
suitable position nearer to the handset.

If you have registered additional handsets to the same base unit, make
sure they are not already on a call. The LCD display on your handset will
display the EXT IN USE symbol if the line is engaged.

The dial mode setting may be incorrect. See the Dial mode section on
page 11 for more information.
TROUBLESHOOTING
Handset does not ring

Check that you have not turned off the ringer volume level. Refer to
Handset ring volume level section on page 13 for more information.

You may have too many extension phones on your line. Try unplugging
some phones.
Call was disconnected
Please move the handset closer to the base unit. You may want to consider moving
the base unit to achieve a greater transmission range.
Keys do not work /
The symbol means that the keypad lock feature has been activated. See the Key
lock section on page 12 for more information.
Phone beeps

The battery may need to be recharged. Put the handset into the charging
cradle of the base unit. It may take up to 15 hours to fully recharge the
battery.

Your handset may temporarily lose its synchronization with the base unit
due to radio interference in your area. When this happens, "OUT OF
SERVICE" shows on handset LCD. You can move closer to the base unit
to help reduce your telephone's susceptibility to radio interference. If you
do not wish to hear the beep tone, you can turn it off following the
instructions under the Key tone section on page 12.
Low battery warning
shows on screen
29

Advertisement

Table of Contents
loading

  Also See for Sanyo LNS-W10

  Related Manuals for Sanyo LNS-W10

This manual is also suitable for:

Clt-w10