Charging The Handset; Security Code; Phone Line Connection - Sanyo CLT-538X Instruction Manual

CHARGING THE HANDSET
SECURITY CODE
1. Place thehandset onthebase stalionfor12 hours. The CHARGE/lN USE
indicator hghts.
" The base stat!on must reconnected lo ACpower. (see page 4.)
This cordless telephone hasadigilal security system with 10,000,000 possible
codes. This system helps prevent the unauthorized use of your telephone Ime by
another cordless Ielephone.
2. Remove thehandset from the base stafion.
From then on, recharge the handset forconfinuous 12 hours when Ihe TALW
BAIT. LOW indicator flashes et a few seconds intewals. (In addition, a beep sounds
at the same intewals during phone uee.)
~
&~ TALIU
Q
S'
BATT.LOW
%%
000
000
03"
Standby time
When the handset battery is fully charged, your Sanyo cordless phone offers up to 14
days of continuous standby time or up to 10 hours of continuous talk time. (Listed
starrdby time is measured under a situation in which handset is kept in standby mode
only–no phone calls are made or received). Under normal usage conditions, recharging
,.
is required more often.
CAUTION: Repeated recharging for shorter periods may reduce battety capacity.
t
PHONE LINE CONNECTION
Note:
Please make sure that the handset battery is fully charged before connecting the
phone fine cable.
a
To teleph
Telephone cord
TEL LINE
WARNINGS
This cordless telephone may, on some longer Vnes, have difficulty franding over
to another device connected to the same line.
Immediately disconnect the equipment should it become physically damaged,
and arrange for its disposal or repair.
The Qperation of this equipment on the same line as telephones or other
equipment with audible warning devices or automatic ring detectors will give
rise to bell tinkle or noise and may cause false tripping of the ring detector.
Should such problems occur, the user is not to contact Telecom Faults Sewice.
How to reset your security code
1. Place thehandset inthebase station cradle
o
0
INTERCOM
PAGEFIND
2. Wtthin8aeconds, press
[INTERCOM.PAG13 FIND]
ontha base station.
The CHARGEilN USE indicator flashes, and then lights steadily. The security
coda is now set.
NOTES:
I Tochange yoursecuri~ codeatany time, simply repeat theabove steps.
A new security code is automatically set each time.
i lfyouexperience tificulty inreseHing security code, first disconnect the AC
adaptor from the unit, reconnect it, and then try again.
CAUTION
This telephone is for use with a "lone dialing system" only. if you have a puise
dialing lines, you can't use this cordless telephone.
5
8