Download  Print this page

Sound Signals; Troubleshooting; Telephone - Sanyo LNS-W10 Instruction Manual

2.4 ghz digital cordless telephone with 2 caller id handsets and extra charger
Hide thumbs

Advertisement

Talking
Charging
Incoming call
Voice mail
No telephone line

SOUND SIGNALS

A long warbling tone
Single tone
Two short beeps
One long beep
Three short beeps
Two short beeps every 15 seconds

TROUBLESHOOTING

TELEPHONE

No dial tone
Check installation:

Is the base unit plugged into the telephone line and AC power source? If
the telephone line is not properly connected to the base unit NO LINE will
appear on the handset display.

Is the AC power source turned on at the socket?

Are the batteries properly installed in the handset?
Dial tone is OK, but cannot dial out

Try moving the handset closer to the base unit.

If this doesn't work, try a different position for the base unit. Typically, the
higher you place the base unit, the better the reception.

The battery charge level may be low. Check the LCD display for the low
battery-warning signal. If the battery is low, place the handset in the base
unit's charging cradle to charge.
Lit steadily (red)
Lit steadily (green)
Flashes in same pattern as telephone ring (red)
Flashes every 2 seconds (red)
Flashes every 1 seconds (red)
Signals an incoming call
A key is pressed
Call waiting / MIC mute
Confirmation tone / Page signal / Call
back
Error tone / Out of range
Low battery warning
28

Advertisement

Table of Contents
loading

  Also See for Sanyo LNS-W10

  Related Manuals for Sanyo LNS-W10

This manual is also suitable for:

Clt-w10