Download  Print this page

Technical Information - Sanyo LNS-W10 Instruction Manual

2.4 ghz digital cordless telephone with 2 caller id handsets and extra charger
Hide thumbs

Advertisement

TECHNICAL INFORMATION

REN Number:
The Ringer Equivalence Number (REN)
assigned to each terminals device
provides an indication of the maximum
number of terminal allowed to be
connected to a telephone interface.
The REN number of this phone is
located on the bottom of the base unit.
The termination on an interface may
consist of any combination of device
subject only to the requirement that the
sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
CAUTION
This product is intended for use in
CANADA only. Sale or use in other
countries may violate local laws.
Cordless telephones use radio
frequencies to allow mobility. This
affects performance of your phone.
1. NOISE
Electrical pulse noise is present in most
homes at one time or another. This is
most intense during electrical storms.
Certain kinds of electrical equipment,
such as light dimmers, fluorescent
bulbs, motors, fans, etc., also generate
pulse noise.
Because radio frequencies are
susceptible to this, you may on occasion
hear pulse noise through the handset.
This is usually only a minor annoyance
and should not be interpreted as a
defect of the phone.
2. RANGE
Because radio frequencies are used, the
location of the base station can affect
the operating range of the phone. Try
several locations and choose the one
that gives the clearest signal to the
handset. (Turning in a circle while
holding the handset may also increase
the operating range.)
3. INTERFERENCE
Electronic circuits activate a relay to
connect the unit to your telephone line.
These electronic circuits operate in the
radio frequency spectrum. While several
protection circuits are used to prevent
unwanted signals, there may be periods
when these unwanted signals enter the
base station. You may hear a click or
hear the relay activate when you are not
using the cordless handset. If this
occurs frequently, you can minimize or
eliminate the problem by lowering the
height of the base station or relocating
the base station. It may also be helpful
to change the operating channel and/or
the security code setting.
Operation is subject to the following two
conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
NOTICE:
Privacy of communications may not be
ensured when using this telephone.
Other devices, including other cordless
telephones, may interfere with the
operation of this cordless telephone or
cause noise during operation. Units
without coded access may be accessed
by other radio communication systems.
Cordless telephones must not cause
interference to any licensed radio
service.
The Industry Canada Label identifies
certified equipment. This certification
means that the equipment meets certain
telecommunications network protective,
operational and safety requirements.
The ministry does not guarantee that the
33

Advertisement

Table of Contents
loading

  Also See for Sanyo LNS-W10

  Related Manuals for Sanyo LNS-W10

This manual is also suitable for:

Clt-w10