Charging The Handset Battery - Sanyo CLT-9660 Instruction Manual

Charging the handset battery
r
IMPORTANT
Charge the handset before using the cordless phone for the first time.
Do not attempt to use the handset before charging it for a full 10 hours.
1
2
3
Place the handset on the base station and charge it
for 10 hours.
Bidirectional handset
The handset can be placed with the keypad facing
up or down.
Remove the handset from the base station.
Set the POWER switch to ON.
The BA1l. LOW indicator will flash when the handset needs recharging. Simply place
the handset in the base station cradle and charge it for 10 hours. It is not necessary to
turn the POWER switch off after initial charging.
Note
The handset battery can be recharged and reused many times.
Repeated recharging for a shorter period may reduce the battery time.
If the handset battery fails (the BATT. LOW indicator flashes) even after being
charged for 10 hours, replace it with a new Sanyo cordless telephone battery,
type 3N-270AA (See page 20).
ATTENTION
Securitv Code Setting
Your cordless telephone is shipped from the fdctory as a matched pair
(handset and base station). Before using the phone check that the serial
number of the handset and base station are the same.
If the serial numbers of the handset and base station do not match or if your
handset does not work with your base station please refer to this Instruction
Manual page 23 for details of the Security Code setting before calling for service.
The Security Code must be set to match the handset to the base station for
correct operation.
8