Power Connection For Drives With A Built-In Emc Filter - Siemens SED2 series Operating Instructions Manual

Terminal layout:
Frame size F
Power connection to the
footprint filter for frame
sizes A to C
Power connection at the
integrated EMC filter for
frame sizes D to F
Siemens Building Technologies
HVAC Products
PE
4.3.5

Power connection for drives with a built-in EMC filter

The SED2 drives with frame sizes A, B, and C are delivered with built-in ready-wired
EMC footprint filters. Route the power supply to the terminals of the pre-installed
footprint filter.
The SED2 drives with frame sizes D, E, and F are delivered with built-in ready-wired
EMC filters. Wire the power supply to the connections of the built-in filter. The diagrams
below show how to access the mains connections of the built-in filter.
SED2 variable speed drives
Electrical installation
R+
DC- B- DC+ DC+
L1 L2 L3 U
B+ B+
DC+
V W
Incoming mains voltage
Ground
Filter
Filter output
31/126
CM1U5192en
01.2002