Introduction: Unit Description
Unit Description
Figure 2. RPS/RDT/RFS/RCS unit
Typical Component Locations
Figure 2 shows an RPS/RDT/RFS/RCS unit. Figure 3 shows a
typical RPS unit with the locations of the major components.
Figure 4 on page 3 shows a typical RDT unit with the locations
of the major components. These figures are for general
information only. See the project's certified submittals for
actual specific dimensions and locations.
Figure 3. Typical component locations—RPS units
Top View
Outside and return air dampersa
Side View
Exhaust
hood
Optional back
return opening
2
Bottom return air opening
Filter section
Supply air fan
Return air
Return air
Return air
Outside air
fan
louvers
Bottom discharge air opening
Power and control entrances
Evaporator coil
Heat section (natural gas, oil,
steam, hot water, electric
Discharge plenum
(main control panel)
Air cooled condenser
IM 738-2